Hi,
The user manual of my DS-9632NI-I8 says I can get the NVR to load balance, if I give both NICs the same IP.
I can certainly do that, but what should I set the "Working Mode" to? "Multi-address" (which seems to be for 2 different networks), or "Network Fault-tolerance" (where one NIC backs up the other)?
There isn't a separate "load balance" option in the dropdown...unless I need to change the IPs or turn off DHCP first...but I wanted to figure out the proper procedure before I create...
DS-9632NI-I8 - Load Balance?
The user manual of my DS-9632NI-I8 says I can get the NVR to load balance, if I give both NICs the same IP.
I can certainly do that, but what should I set the "Working Mode" to? "Multi-address" (which seems to be for 2 different networks), or "Network Fault-tolerance" (where one NIC backs up the other)?
There isn't a separate "load balance" option in the dropdown...unless I need to change the IPs or turn off DHCP first...but I wanted to figure out the proper procedure before I create...
DS-9632NI-I8 - Load Balance?